How to Disassemble a Moen Kitchen Faucet
- Locate the setscrew in the handle.
- Pry off the cap on top of the handle with a screwdriver to expose the screw, if necessary.
- Unscrew the set screw in the handle.
- Lift off the handle, exposing a round stainless cartridge collar with an indent that points up.
- Remove this cartridge collar by pulling up on it manually.
How do you remove a Moen faucet handle?
Some Moen faucets have handles that remove by loosening the screw in the back of the handle. To loosen this screw use a 3/32″ hex wrench. After the handle has been removed unscrew the spout collar nut by turning counterclockwise then lift and rotate the spout.
Why is my Moen kitchen faucet leaking?
Water Leaking Due to Worn O- Ring
There are generally two causes of water leaking from your Moen faucet. Because pull-out spray faucets have a single handle, the most common cause of the water leaking is the O-ring. To replace the O-ring, turn off the water to the faucet from below the counter.
How do you replace a Moen single handle kitchen faucet?
How to Fix a Moen Single Handle Kitchen Faucet
- Turn the water supply pipes in a clockwise direction to turn the water off.
- Remove the handle.
- Remove the cam nut and the spout to access the ball assembly.
- Lift the circular plastic cam off of the faucet assembly, followed by the metal ball.
- Press each replacement valve spring onto its replacement valve seat.
How do you change a cartridge in a Moen kitchen faucet?
Where is the model number on a Moen faucet?
The model/series number is usually a four or five digit number beginning with “7” or “8” and may be followed by letters. The series number may sometimes be found on the underside of the spout. The series number is often found on the back of the decorative ring located at the bottom of the spout.
How do you loosen a faucet handle?
A faucet becomes tight with use.
- Cut the water supply to the faucet handle by turning the shut-off valve clockwise.
- Locate the button cap on top of the tight faucet handle.
- Pry off the button cap with the standard screwdriver.
- Unscrew the screw in the center of the handle, using the Phillips screwdriver.
